ChemSan

Chemisphere ChemSan Self Foaming No Rinse Sanitiser

Dilution: 0.2%, 10ml to 5 litres of water.

Higher concentrations will require a potable rinse.

All surfaces should be cleaned and rinsed beforehand.

Minimum contact time 2 minutes.

The solution should remain at a pH at 3 or below to maintain proper sanitising level.

If using the diluted solution over time, check the pH regularly using pH papers.

Hand Utensils, Tanks, Vats, home brew use: pre-clean dirty surfaces.

Clean all surfaces using a suitable detergent, following label directions.

Rinse with potable water.

Apply diluted solution on surfaces with a cloth, mop ,brush, sponge, spray or by immersion.

After 2 minutes contact time, drain solution thoroughly.

For all applications, allow to air dry, however surfaces must remain wet for at least two minutes.

Do not rinse after Chemsan application.