ChemSan
Chemisphere ChemSan Self Foaming No Rinse Sanitiser
Manufacturer's data sheet
Product description
Dilution: 0.2%, 10ml to 5 litres of water.
Higher concentrations will require a potable rinse.
All surfaces should be cleaned and rinsed beforehand.
Minimum contact time 2 minutes.
The solution should remain at a pH at 3 or below to maintain proper sanitising level.
If using the diluted solution over time, check the pH regularly using pH papers.
Hand Utensils, Tanks, Vats, home brew use: pre-clean dirty surfaces.
Clean all surfaces using a suitable detergent, following label directions.
Rinse with potable water.
Apply diluted solution on surfaces with a cloth, mop ,brush, sponge, spray or by immersion.
After 2 minutes contact time, drain solution thoroughly.
For all applications, allow to air dry, however surfaces must remain wet for at least two minutes.
Do not rinse after Chemsan application.
Return Links:
Home ¦ GMP ¦ Cleaning¦ Cleaning Plan