ChemSan: Difference between revisions
mNo edit summary |
mNo edit summary |
||
| Line 4: | Line 4: | ||
[https://hunuhq.com/docs/GMP_Docs/Data%20Sheets/ChemSan-HS-Data-Sheet.pdf ChemSan COSHH Sheet] | [https://hunuhq.com/docs/GMP_Docs/Data%20Sheets/ChemSan-HS-Data-Sheet.pdf ChemSan COSHH Sheet] | ||
ChemSan Product Data Sheet | [https://hunuhq.com/docs/GMP_Docs/Data%20Sheets/Chemsan-Information-Sheet-FAQs-compressed.pdf ChemSan Product Data Sheet] | ||
=== Product description === | === Product description === | ||
Revision as of 09:41, 17 January 2024
Chemisphere ChemSan Self Foaming No Rinse Sanitiser
Manufacturer's data sheet
Product description
Dilution: 0.2%, 10ml to 5 litres of water.
Higher concentrations will require a potable rinse.
All surfaces should be cleaned and rinsed beforehand.
Minimum contact time 2 minutes.
The solution should remain at a pH at 3 or below to maintain proper sanitising level.
If using the diluted solution over time, check the pH regularly using pH papers.
Hand Utensils, Tanks, Vats, home brew use: pre-clean dirty surfaces.
Clean all surfaces using a suitable detergent, following label directions.
Rinse with potable water.
Apply diluted solution on surfaces with a cloth, mop ,brush, sponge, spray or by immersion.
After 2 minutes contact time, drain solution thoroughly.
For all applications, allow to air dry, however surfaces must remain wet for at least two minutes.
Do not rinse after Chemsan application.