Bottling procedure: Difference between revisions

Revision as of 14:55, 22 January 2024

The following is the process for bottling product.

Do not carry out this proceedure if you have not completed the HuNu Training for this task.

Wash hands (See Effective Hand Washing Technique)
Put on disposable nitrile gloves
Confirm with the site manager the quantity of bottles to be filled (BotQty)
Ensure that there are at least BotQty bottles sterilised and ready to be used at the bottling station.
Check with the site manager that the system can be set to "Bottling Mode"
If given approval, set the system to "Bottling Mode"
Prepare a tray with a fresh sheet of kitchen paper. Place the tray to the right of the filling station.
Place a bottle under the filling spout and press the "Fill button".
When the flow stops, remove the bottle, place it on the tray prepared in (7)
When the tray is full, pass it along to the labeling station. Then repeat from (7) until all bottles have been filled
Return the system to "Production Mode"
Remove & clean the filling spout
Gather 24 bottles and install them on the carrier. NEVER use less than 24 bottles
Prepare

@@ Line 5: / Line 5: @@
 Do not carry out this proceedure if you have not completed the [[Training Plan|HuNu Training]] for this task.
-# Gather 24 labelled bottles and install them on the carrier. NEVER use less than 24 bottles.
+# Wash hands (See [https://hunuhq.com/docs/GMP_Docs/House_Rules_PDFs/Effective%20Hand%20Washing.pdf Effective Hand Washing Technique])
+# Put on disposable nitrile gloves
+# Confirm with the site manager the quantity of bottles to be filled (''BotQty'')
+# Ensure that there are at least ''BotQty'' bottles sterilised and ready to be used at the bottling station.
+# Check with the site manager that the system can be set to "Bottling Mode"
+# If given approval, set the system to "Bottling Mode"
+# Prepare a tray with a fresh sheet of kitchen paper. Place the tray to the right of the filling station.
+# Place a bottle under the filling spout and press the "Fill button".
+# When the flow stops, remove the bottle, place it on the tray prepared in (7)
+# When the tray is full, pass it along to the labeling station. Then repeat from (7) until all bottles have been filled
+# Return the system to "Production Mode"
+# Remove & clean the filling spout
+# Gather 24 bottles and install them on the carrier. NEVER use less than 24 bottles
 # Prepare